Red Orgonite Pendant with Copper Wire Wrapped Setting

Completely hand made copper wire wrapped pendant with red orgonite cabochon. Even the orgonite cabochon is handmade with clear resin and copper. Cabochon is set in handmade wire wrapped copper. Patina finish and hand polished.

Orgonite Pendent Mounted in Wire Wrapped Jewelry

I mounted a previously made orgonite pendent using a wire wrap jewelry technique. Wire is made of copper. Click the picture to see it up close.

Small Orgone Accumulator with joule Theives

Top View

I made this Orgone Accumulator pendant using Castin' Craft clear liquid casting resin from Michaels. For a mold I used a small glass candle holder. I created some circuitry in this one. All the copper coils are linked to joule thieves made of copper wire wound around magnetized ferrite steel. The copper wire comes together in the middle and is wound around the large crystal you see on the top. There is also smaller crystals in between each copper coil.

Top Zoom
Closer view

Bottem View

In the bottom view of this orgone accumulator you can see small pieces of magnetized ferrite (stuff in black). I put a large SBB coil in here to pull the ether energy from the bottom and direct it over the circuitry inside. The cleaned energy is blasted out the top.

Small Simple Orgone Accumulator With Large Crystal

Top View

I made this Orgone Accumulator pendant using Castin' Craft clear liquid casting resin from Michaels. For a mold I used a small glass candle holder. The large crystal on top, I grew from magnesium sulfate (epsom salt). There are also smaller crystals made from magnesium sulfate. Small coils and springs of copper wire. There is also some metals from copper and aluminum scouring pads.

Bottom View
There is a large copper coil gowing around the bottom. You can also see more of the copper and aluminum scouring pad pieces.

Orgone Accumulator Pendant

I made this Orgone Accumulator pendant using Castin' Craft clear liquid casting resin from Michaels. For a mold I used a small glass candle holder. I twisted and shaped some copper wire in a random spider web like pattern as the top layer. Around the outside is braided copper wire with red coating. The next layer contains hundreds of aqua-marine crystals that I grew from a Smithsonian crystal growing kit. The crystals are grown from monoammonium phosphate.

Cone Shaped Orgone Accumulator

I made this Orgone Accumulator using Castin' Craft clear liquid casting resin from Michaels. There is one large crystal in the center near the top. I positioned four other crystals around the larger one. I made all of the crystals from magnesium sulfate (Epsom Salt). I used a lot of small copper wires that I cut in varying lengths. Some of the copper wires where made into coils and springs. I also used a bunch of gold and other colored glitter.

This orgone accumulator is really good for massaging. My girlfriend sprained her foot and it was really swollen. The swelling went down by more than 50% within a few minutes of massaging with the orgone accumulator. After massaging her foot for about 15 minutes, the swelling was down by about 80%. 

Orgone Accumulator with Dried Purple Flowers, Crystals, & Copper

Top View

I made this Orgone Accumulator using Castin' Craft clear liquid casting resin from Michaels. For a mold I used a 1 & 1/2 inch glass candle holder.

Bottom View

Inside this orgone accumulator I put some dried purple flowers, tons of small cut up copper wire, and I made an infinity symbol out of copper wire. I put tons of small crystals that I grew from magnesium sulfate (epsom salt). There is also one larger cyrstal that I grew from magnesium sulfate in the middle.